Air enters the compressor of a test facility at 80 °F and 14.5 psia. It is then compressed isentropically to 500 psia and transported to the test cell. At the cell inlet some of the gas is pulled off in a tube for humidity measurements. The tube is maintained at a temperature of 200 °F into the test cell where the sensor is located. Is that line temperature sufficient to ensure a successful measurement of the cell entrance humidity?

Study the following reaction carefully. what classification should this reaction have? 4al + 3o2 2al2o3synthesisdecompositionsingle replacementdouble displacement

Aball is thrown straight up into the air with a speed of 21 m/s. if the ball has a mass of 0.1 kg, how high does the ball go? acceleration due to gravity is g = 9.8 m/s^2. a. 22.5 m b. 20.0 m c. 25.0 m d. 17.5 m

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)