Physics, 02.06.2020 17:58 LMixer5sosCR7Fan

A) Fill in the blanks in the following paragraph to correctly describe the nucleus of an atom.
and are the two types of nucleons that make up a nucleus. The force exists between in the nucleus because of their charge. Because it is repulsive, this force tends to make a nucleus . However, the force acts between protons, between neutrons, and between protons and neutrons. This force helps to make a nucleus , because it is always attractive.

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 02:10

Astudent is performing an experiment comparing sound and light waves. the student gathers the following data. what conclusion does the student most likely make based on this data? light waves always travel the same speed; however, the speed of sound is determined by the medium that it travels through. all sound waves always have the same energy, so the temperature of the medium does not affect wave speed. light needs to vibrate particles, so it travels fastest in tightly packed solids, while sound does not need a medium, so it travels fastest in a gas. tightly packed particles in solids slow down the light waves; however, sound waves make particles bounce into each other, so they travel faster in solids.

Answers: 3

Answer

Physics, 22.06.2019 05:10

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.

Answers: 3

Answer

Physics, 22.06.2019 12:30

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

Answer

Physics, 22.06.2019 15:30

What can you increase the strength of an electromagnet by

Answers: 2

Answer

You know the right answer?

A) Fill in the blanks in the following paragraph to correctly describe the nucleus of an atom.

Questions