Physics, 18.06.2020 03:57 Joejar63

You hold block A with a mass of 1 kg in one hand and block B with a mass of 2 kg in the other. You release them both from the same height above the ground at the same time. (Air resistance can safely be ignored as they fall.) Which of the following describes and explains the motion of the two objects after you release them? A) Before A hits the ground before the block B. The same force of gravity acts on both objects, but because block A has a lower mass, it will have a larger acceleration
B) Block B hits the ground before the block A. The larger force on block B causes it to have a greater acceleration than block A
C) The two blocks hit the ground at the same time, because they both ackelerate at the same rate while falling. The greater gravitational force on block B is compersated giving it the same acceleration
D) The two blocks hit the ground at the same time because they move at the same constant speed while falling. The force on the blocks are irrelevent once they start falling

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 19:30

Act has a 1200: 5 or 240: 1 turns ratio. it is short circuited. what is the maximum current at 1200a primary if we put a 100ohm resistor across the secondary end of the ct. use it as current source circuit.

Answers: 2

Answer

Physics, 22.06.2019 05:10

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.

Answers: 3

Answer

Physics, 22.06.2019 15:20

Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2

Answers: 2

Answer

Physics, 22.06.2019 15:20

Arigid tank is divided into two equal parts by a partition. one part of the tank contains 3 kg of compressed liquid water at 400 kpa and 60°c while the other part is evacuated. the partition is now removed, and the water expands to fill the entire tank. determine the entropy change of water during this process, if the final pressure in the tank is 40 kpa. use steam tables.

Answers: 3

Answer

You know the right answer?

You hold block A with a mass of 1 kg in one hand and block B with a mass of 2 kg in the other. You r...

Questions