A 14.0-lb beam is supported by two 8.00-lb cylinders placed under it. A 5.00-lb magnitude force pulls the beam at its end, coplanar with its surface as depicted. As the beam moves forward, the cylinders roll without slipping relative to the floor and beam. (a) At the instant the cylinders are equidistant from each end, what is the acceleration of the beam? (b) What is the acceleration of the cylinders? (c) Determine the frictional forces at this time

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

An insulated 40 ft^3 rigid tank contains air at 50 psia and 120°f. a valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. the air temperature during this process is kept constant by an electric resistance heater placed in the tank. determine the electrical work done during this process.

Amass weighing 24 pounds, attached to the end of a spring, stretches it 4 inches. initially, the mass is released from rest from a point 8 inches below the equilibrium position. find the equation of motion. (use g = 32 ft/s2 for the acceleration due to gravity.)