subject
Physics, 21.06.2020 00:57 giovney

Events 1 and 2 are exploding firecrackers that each emit light pulses. In the reference frame of the detector, event 1 leaves a char mark at a distance 3.80 m from the detector, and event 2 leaves a similar mark at a distance 2.10 m from the detector. The two events are simultaneous in the reference frame of the detector and occur at instant t, at what instant of time will each light pulse be detected?

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
question
Physics, 22.06.2019 02:00
Which statements about tornadoes are true? check all that apply. (a) about 12,000 tornadoes hit the united states every year. (b) a tornado looks like a funnel. (c) tornadoes are deadly atmospheric storms that cause millions in damages each year. (d) tornadoes can reach wind speeds of more than 300 miles per hour. (e) kansas is the state with the most tornadoes. (f) you will always notice a funnel before a tornado strikes.
Answers: 2
question
Physics, 22.06.2019 06:20
Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.
Answers: 1
question
Physics, 22.06.2019 15:20
Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2
Answers: 2
You know the right answer?
Events 1 and 2 are exploding firecrackers that each emit light pulses. In the reference frame of the...
Questions
Questions on the website: 13722361