subject
Physics, 27.06.2020 18:01 homelanie21

After fixing a flat tire on a bicycle you give the wheel a spin. Its initial angular speed was 7.35 rad/s and it rotated 15.0 revolutions before coming to rest. What was the average angular acceleration? For what length of time did the wheel rotate?

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 10:30
The precision of a laboratory instrument is ± 0.05 g. the accepted value for your measurement is 7.92 g. which measurements are in the accepted range? check all that apply. 7.85 g 7.89 g 7.91 g 7.97 g 7.99 g
Answers: 1
question
Physics, 22.06.2019 16:30
Large electric fields in cell membranes cause ions to move through the cell wall. the field strength in a typical membrane is 1.0 x 10 7 n/c. what is the magnitude of the force on a calcium ion with charge +e? what is its acceleration? is it possible for a particle with the same charge as as calcium to have a different acceleration if placed at this location? what would change the acceleration: mass of the particle? diameter of the particle?
Answers: 2
question
Physics, 22.06.2019 17:20
In a system with only a single force acting upon a body, what is the relationship between the change in kinetic energy and the work done by the force? answers: work is equal to the change in kinetic energy.work depends on the square of the change in potential energy.work is equal to the negative of the change in kinetic energy.work is equal to the square of the change in kinetic energy
Answers: 2
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
You know the right answer?
After fixing a flat tire on a bicycle you give the wheel a spin. Its initial angular speed was 7.35...
Questions
question
Chemistry, 30.12.2019 23:31
Questions on the website: 13722361