Please someone to help me with this will be very grateful In a light bulb, how is electrical energy transformed into light? and in an LED, will it be the same?

LED;

      The energy of photons emitted by an LED is dictated by the band gap of the semiconductor used – the energy required to make an electron–hole pair. When an electron and hole recombine in a radiative process, a photon carries away the extra energy.

BULB

        In the light bulb, the flow of charge through the filament heats it up and causes it to glow. In this way, the light bulb converts electrical energy to heat energy and light energy. ... 1, chemical potential energy is converted to electrical energy, which is immediately converted to light energy and heat energy

       This flow of charge converts chemical potential energy into electrical energy. In the light bulb, the flow of charge through the filament heats it up and causes it to glow. In this way, the light bulb converts electrical energy to heat energy and light energy. bulb have a fillament but LED have no filament they produce energy through clod process but bulb have a filament and they produce energy through hot process

Explanation:

This progression of charge changes over substance expected vitality into electrical vitality. In the light, the progression of charge through the fiber warms it up and makes it shine. Along these lines, the light believers electrical vitality to warm vitality and light vitality.

hope soo u can understand my point

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

from

explanation:

wind is defined by the direction it blows from.   for example, a wind blowing from north to south is called a northerly wind.