Physics, 17.07.2020 02:01 PrincessIndia

A positively charged light metal ball is suspended between two oppositely charged metal plates on an insulating thread as shown below. After being charged once, the plates are disconnected from the

battery. Describe the behavior of the ball. Please use 3 content related sentences.

(ref: p.553-561)

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 04:50

Unpolarized light whose intensity is 1.19 w/ is incident on a polarizer. (a) what is the intensity of the light leaving the polarizer? (b) if the analyzer is set at an angle of = 41.0∘ with respect to the polarizer, what is the intensity of the light that reaches the photocell?

Answers: 1

Answer

Physics, 22.06.2019 08:00

The arrival of in the early days of europa’s existence could have formed its ocean. it is likely that the water experienced similar to earth. it is also possible that this water is retained beneath europa’s surface and in its atmosphere due to europa’s . 1.) a. precipitation b. water vapor c. icy debris 2.) a. gravitational compression b. biochemical cycling c. radiogenic heating 3.) a, gravity b. magnetic field c. heat energy for plato

Answers: 3

Answer

Physics, 23.06.2019 02:10

Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.

Answers: 1

Answer

Physics, 23.06.2019 06:30

Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?

Answers: 2

Answer

You know the right answer?

A positively charged light metal ball is suspended between two oppositely charged metal plates on a...

Questions