Physics, 27.07.2020 01:01 ishaanbaruah3040

. A 24-V battery is attached to a 3.0-mF capacitor and a 100-ohm resistor. If the capacitor is initially uncharged, what is the voltage across the capacitor 0.16 seconds after the circuit is connected to the battery

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 06:30

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?

Answers: 3

Answer

Physics, 22.06.2019 06:50

What is the stall speed at sea level of an airplane that weights 10000 lbs., has a wing area of 300ft^2, and a maximum lift coefficient of 1.4? what is the stall speed if flaps that double cl,max are applied?

Answers: 1

Answer

Physics, 22.06.2019 11:20

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Answers: 3

Answer

Physics, 22.06.2019 23:00

Which of the following is another term for a planned economy

Answers: 1

Answer

You know the right answer?

. A 24-V battery is attached to a 3.0-mF capacitor and a 100-ohm resistor. If the capacitor is initi...

Questions