A thermal conductivity detector is used in all of the GCs in our lab to measure the amount of each component (analyte) in a sample. Which statement best describes how a thermal conductivity detector works when an analyte flows over the wire filaments in the detector

The thermal conductivity detector (TCD) is a widespread detector dependent on the estimation of the thermal conductivity of a gas. It measures the distinction in heat conductivity between unadulterated carrier gas and carrier gas containing test parts.

Explanation:

When you have two parallel tubes both containing gas and coils being heated, thermal conductivity occurs. The gases are inspected by comparing the rate of heat loss in the heated coils in the gas. One of the cylinders has a reference gas and the other cylinder contains the sample to be tested. A thermal conductivity detector will sense the change in the thermal conductivity and compares it to a reference stream of carrier gas. An analyte washed from the section causes the reduction of the thermal conductivity of the effluent and produces a detectable signal. The thermal conductivity of most compounds is less than the thermal conductivity of hydrogen and helium.

a solenoid is created by wrapping a l = 90 m long wire around a hollow tube of diameter d = 4.5 cm.   the wire diameter is d = 0.9 mm.   the solenoid wire is then connected to a power supply so that a current of i = 9 a flows through the wire.

randomized variablesl = 90 m

d = 4.5 cm

d = 0.9 mm

i = 9 a                                          

write an expression for the number of turns, n, in the solenoid. you do not need to take into account the diameter of the wire in this calculation.

calculate the number of turns, n, in the solenoid.

write an expression for the length of the solenoid (l2) in terms of the diameter of the hollow tube d.

calculate the length of the solenoid (l2)   in meters.

calculate the magnitude of the magnetic field at the center of the solenoid in teslas.

explanation:

no

sodium is solid at rt