(Q004) During World War II, the military imaged the seafloor by sending pulses of sound waves down through the water and measuring the time it took for the sound to bounce off the seafloor and return to the receiver. This method is called

Sonar

Explanation:

Sonar is a technique that involves the use of sounds in viewing substances in a water medium to aid movement or communication. It makes use of the advantage of sound waves traveling faster and farther in water when compared to other types of waves such as light waves.

During World War II, the military employed the use of SONAR in imaging the seafloor by sending pulses of sound waves down through the water and measuring the time it took for the sound to bounce off the seafloor and return to the receiver.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).