Which scenario could be represented by the motion map? A car speeds up to merge onto the freeway and then continues at a constant velocity.
A car speeds up to pass a truck, then slows down to a constant velocity.
A car slows to stop at a stop sign. Once traffic is clear, the car speeds up.
A car slows to makes a U-turn, then continues in the opposite direction.

Air is held within a frictionless piston-cylinder container, which is oriented vertically. the mass of the piston is 0.45 kg and the cross-sectional area is 0.0030 m2. initially (state 1) the pressure of the gas is sufficient to support the weight of the piston as well as the force exerted by the atmospheric pressure ( 101.32 kpa). the volume occupied by the air within the cylinder in state 1 is 1.00 liter. one end of a spring (with spring constant k = 1000 n/m) is attached to the top of the piston, while the other end of the spring is attached to a stage that can move vertically. initially the spring is undeflected and therefore exerts no force. then the stage is then moved quasistatically downward a distance of 10.0 cm, at which point the system reaches state 2. the piston-cylinder is not insulated; rather it remains in diathermal contact with the surroundings, which are at a constant temperature of 300 k. what is the change of pressure within the container?

Question 7 [2 marks] in the circuit below, the electromotive force generated by the battery is e = 6.0 v, and the resistances are r1 = r4 = 1.0 q, r2 = r3 =2.0 q. r. the power delivered by the battery to the circuit is closest to a. 6 w в. 12 w с. 15 w d. 18 w e. 20 w final exam autumn 2014 page 5 of 9 68037 physical modelling faculty of science [2 mark] question 8 with reference to question 7, the current through resistor r2 is closest to a. 1 a в. 2 а c. 3 a d. 4 a e. 6 a

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)