subject
Physics, 20.09.2020 14:01 rchapman414

A thin, square, conducting plate 52.5 cm on a side lies in the xy plane. A total charge of 3.25 10-8 C is placed on the plate. You may assume that the charge density is uniform. (a) Find the charge density on each face of the plate. (b) Find the electric field just above the plate. (c) Find the electric field just below the plate.

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 08:30
A17,250 kg rocket is pushed with a thrust of 6,450,284 n. what is the acceleration of the rocket?
Answers: 1
question
Physics, 22.06.2019 15:00
10 points! will mark brainiest! in a heat engine if 1,000 j of heat enters the system and the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2,000 j 1: write the equation 2: list out your known variables 3: plug the numbers into the equations 4: solve 5: write your solution statement that includes initial energy and final energy added you so much!
Answers: 3
question
Physics, 22.06.2019 19:30
In this thread, i would like you to comment on the nature of light and how operation of telescopes. light has a duality of a particle and a wave; which one affects your life? also how does light interact with optics inside telescopic systems? answer these questions in two paragraphs. then respond the another students response.
Answers: 1
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
A thin, square, conducting plate 52.5 cm on a side lies in the xy plane. A total charge of 3.25 10-8...
Questions
question
Mathematics, 15.10.2020 09:01
question
Mathematics, 15.10.2020 09:01
question
Biology, 15.10.2020 09:01
question
Mathematics, 15.10.2020 09:01
question
Mathematics, 15.10.2020 09:01
question
Mathematics, 15.10.2020 09:01
Questions on the website: 13722360