A 30-kVA 8000/230-V distribution transformer has an impedance referred to the primary of 20 + j100 Ω. The components of the excitation branch referred to the primary side are RC =100 kΩ and XM =20 kΩ (a) If the primary voltage is 7967 V and the load impedance is ZL= 2.0 + j0.7 Ω. what is the secondary voltage of the transformer? What is the voltage regulation of the transformer? (b) If the load is disconnected and a capacitor of –j3.0 Ω is connected in its place, what is

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Física: un futbolista patea hacia el arco con una velocidad de 15m/ah, calcular: a)el alcance para un ángulo de tiro de 25º, b) el tiempo que el balón permanece en el aire.

Aloop of wire is in a magnetic field such that its axis is parallel with the field direction. which of the following would result in an induced emf in the loop? choose all that apply. a loop of wire is in a magnetic field such that its axis is parallel with the field direction. which of the following would result in an induced emf in the loop? choose all that apply. moving the loop outside of the magnetic field region. spin the loop such that its axis does not consistently line up with the magnetic field direction. change the magnitude of the magnetic field. change the diameter of the loop