subject
Physics, 30.10.2020 20:00 dakulrzz3

a ball is pushed from a stop and rolls 6m in 2s. Student A says the average speed of the ball is 3m/s. Student B says the average speed of the ball is 1.5m/s. Which student is correct? Explain your answer

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 17:30
The ballistic pendulum was invented in 1742 by english mathematician benjamin robins. it consists of an initially stationary pendulum that moves after being struck by a bullet, and it is used to measure the original velocity of the bullet. the known variables are the bullet's mass m, the pendulum's mass m, and the height to which the block and bullet swing, determined by the length of the pendulum l and final angle θ. two principles of physics are necessary to solve for the bullet's original velocity. what are these principles? conservation of momentum and newton's third law conservation of energy and conservation of angular momentum grade summary deductions 0% potential 100% conservation of momentum and newton's second law. newton's second law and conservation of angular momentum. conservation of energy and newton's third law conservation of momentum and conservation of angular momentum. conservation of momentum and conservation of energy conservation of energy and newton's second law.
Answers: 2
question
Physics, 22.06.2019 16:20
What organization and environment is described above?
Answers: 1
question
Physics, 23.06.2019 04:31
Which of the following is probably the least necessary character trait needed to be a good clinical nurse?
Answers: 3
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
a ball is pushed from a stop and rolls 6m in 2s. Student A says the average speed of the ball is 3m/...
Questions
question
Health, 04.08.2019 15:00
question
Physics, 04.08.2019 15:00
question
Physics, 04.08.2019 15:00
Questions on the website: 13722363