Physics, 14.11.2020 03:20 tyrickdavis1

Anyone bored and would like to go on zoom

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 09:00

When a light bulb shines, it gives off light energy and energy. a. heat b. potential c. chemical d. electrical

Answers: 2

Answer

Physics, 22.06.2019 12:30

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

Answer

Physics, 22.06.2019 18:30

Abaseball is thrown from the outfield toward the catcher. when the ball reaches its highest point, which statement is true? (a)its velocity is not zero, but its acceleration is zero. (b) its velocity and its acceleration are both zero. (c) its velocity is perpendicular to its acceleration. (d) its acceleration depends on the angle at which the ball was thrown. (e) none of the above statements are true.

Answers: 1

Answer

Physics, 22.06.2019 19:10

3. a worker pushes a 30.5 kg polished stone along a polished table with a force on bonin a straight line for 5.20 s after starting from rest. there is no friction between thestone and the table. at the end of the table. the stone is hooked to a cable with a lengthof 62.0 cm to rotate it to a rough table to store until they can be picked up. the roughtable has a coefficient of static friction 0.702 with the polished stone. remember that 8= 9.80 m/s2a) what is the speed of the stone when it is hooked to the cable? b) what is the tension in the cable while the stone is rotating? (there is still nofriction)c) how much force is needed to make the stone begin sliding from rest on therough table? ius = 0.70262.0 cm30.5 kg20.5 kg6= 0

Answers: 2

Answer

You know the right answer?

Anyone bored and would like to go on zoom...

Questions