Physics, 16.11.2020 17:50 YoVeoAnime
A 20.0 cm wrench is used to generate a torque at a bolt. A force of 50 N is applied at the end of the wrench at an angle of 60.0 degrees to the wrench. The torque generated at the bolt is:
a. 4.9 N•m.
b. 5.7 N•m.
c. 6.0 N•m.
d. 7.5 N•m.
e. 8.7 N•m.
Answers: 3
Physics, 21.06.2019 23:10
A248-g piece of copper is dropped into 390 ml of water at 22.6 °c. the final temperature of the water was measured as 39.9 °c. calculate the initial temperature of the piece of copper. assume that all heat transfer occurs between the copper and the water. remember, the density of water is 1.0 g/m
Answers: 1
Physics, 22.06.2019 14:40
An athlete is holding 24 lb of weights at a height of 6 inches above the stack as shown. to lower the weights, she applies a constant force of 5 lb to the handle. determine the velocity of the weights immediately before they hit the stack.
Answers: 1
Physics, 22.06.2019 18:30
Aprotein molecule in an electrophoresis gel has a negative charge. the exact charge depends on the ph of the solution, but 30 excess electrons is typical. what is the magnitude of the electric force on a protein with this charge in a 1600n/c electric field? write in two significant numbers, and also in newton
Answers: 2
A 20.0 cm wrench is used to generate a torque at a bolt. A force of 50 N is applied at the end of th...
Mathematics, 13.02.2020 01:35
Mathematics, 13.02.2020 01:35
Mathematics, 13.02.2020 01:35
Health, 13.02.2020 01:35
Mathematics, 13.02.2020 01:35
English, 13.02.2020 01:35
Social Studies, 13.02.2020 01:35
Mathematics, 13.02.2020 01:35
Mathematics, 13.02.2020 01:35
Computers and Technology, 13.02.2020 01:35