subject
Physics, 19.11.2020 01:00 lillovecandy

100 J of work was done to lift a 10-N rock and set it at Position A near the edge of a cliff. 1. If the 100 Joules of work lifted the rock to the top of the cliff, how much potential energy did the rock gain?

2. At point C, the rock’s potential energy will be _.

3. The rock’s kinetic energy at point A is _.

4. At point B, some of the rock’s potential energy will be changed to _ energy.

5. What is the mass of the rock?

6. What is the rock’s velocity just before it hits the ground?


100 J of work was done to lift a 10-N rock and set it at Position A near the edge of a cliff.

1.

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 02:30
What are the factors that affect the resistance of a wire?
Answers: 1
question
Physics, 22.06.2019 05:50
There are two routes similar in terrain; however, one route has an incline of approximately 28 degrees, and you must decide on which route to take. what is the maximum road grade that your fully loaded ecv can climb?
Answers: 2
question
Physics, 22.06.2019 06:10
Africtionless piston-cylinder contains 50 l of saturated liquid r-134a. the piston has a mass and an area resulting in an applied pressure of 500 kpa on the refrigerant. the refrigerant is now heated until its temperature rises to 70∘c. calculate the work (in kj) done during this process.
Answers: 3
question
Physics, 22.06.2019 07:30
Clothes dryer uses about 7 amps of current from a 240 volt line. how much power does it use?
Answers: 1
You know the right answer?
100 J of work was done to lift a 10-N rock and set it at Position A near the edge of a cliff. 1. If...
Questions
question
Mathematics, 03.03.2021 01:00
question
Mathematics, 03.03.2021 01:00
question
Chemistry, 03.03.2021 01:00
question
Mathematics, 03.03.2021 01:00
question
Computers and Technology, 03.03.2021 01:00
question
Mathematics, 03.03.2021 01:00
Questions on the website: 13722361