subject
Physics, 06.12.2020 04:50 naynay1997

A student must determine the effect of friction on the mechanical energy of a small block as it slides up a ramp. The block is launched with an initial speed vo from point A along a horizontal surface of negligible friction. It then slides up a ramp, where friction is not negligible, that is inclined at angle with respect to
the horizontal, as shown in the figure. The student measures the maximum vertical height h attained by the block while on the ramp, labeled as point in the
figure. At point B, the block comes to rest. The student performs three trials with the ramp at different angles, launching the block at the same initial speed vo
for each trial. The results from the trials are displayed in the table.
How should the student use the data collected and the known quantities from the experiment to determine the initial total mechanical energy of the block-ramp-
Earth system for all trials in the experiment?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 22:00
Bernie drove home from a vacation in 1.5 hours. he traveled a total distance of 60 miles. what was his average speed in miles per hour? a. 60 mph b. 90 mph c. 40 mph d. 55mph
Answers: 1
question
Physics, 22.06.2019 04:30
Afeather of mass 0.001 kg falls from a height of 2 m. under realistic conditions, it experiences air resistance. based on what you know about friction, what can you say about the kinetic energy of the feather as it reaches the ground? acceleration due to gravity is g = 9.8 m/s2. a. ke < 0.0196 j b. ke = 00196 j c. je = 0 j d. ke > 0.0196 j
Answers: 1
question
Physics, 22.06.2019 12:20
A2.0 μf capacitor and a 4.0 μf capacitor are connected in series across a 0.827-kv potential. the charged capacitors are then disconnected from the source and connected to each other with terminals of like sign together. find the voltage across each capacitor.
Answers: 2
question
Physics, 22.06.2019 13:00
Aplayground merry-go-round has a radius of 4.6 m and a moment of inertia of 200 kg-m2 and turns with negligible friction about a vertical axle through its center. a child applies a 26.0 n force tangentially to the edge of the merry-go-round for 15.0 seconds. if the merry-go-round is initially at rest, how much work did the child do on the merry-go-round?
Answers: 1
You know the right answer?
A student must determine the effect of friction on the mechanical energy of a small block as it slid...
Questions
question
Mathematics, 21.10.2020 05:01
question
Mathematics, 21.10.2020 05:01
question
Mathematics, 21.10.2020 05:01
question
Mathematics, 21.10.2020 05:01
Questions on the website: 13722361