Physics, 22.12.2020 08:10 uliseshinojosa8

A 2200 kg car moving at 31 m/s comes to a complete stop. What is the work done by the breaks of the car?

Answers: 3

Show answers

Answers

Answer from: valejuan

The brakes of this car did approximately $\left(-1.1 \times 10^{6}\; \rm J\right)$ of work. (Rounded to two significant figures. Assumption: this car is moving horizontally, and that all the lost kinetic energy could be attributed to the braking force.)

Explanation:

Is the work of this braking force positive, zero, or negative?

The first step is to find out whether the work of the brakes on the car is greater than zero, smaller than zero, or equal to zero. That could be achieved by comparing:

the direction of this braking force, andthe direction in which the target of the braking force (i.e., the rest of the car) has moved.

In this example, the braking force constantly points backwards. On the other hand, the car kept moving forward (until it stopped.)

In other words, the braking force continuously points in the opposite direction of the motion of its target (the car) until the car came to a stop. Therefore, the work of that this braking force has done should be smaller than zero (i.e., negative.)

What is the magnitude of the work that this braking force has done?

Assume that this car is moving horizontally on level ground. Ideally, the amount of work that this braking force has done would be equal to the amount of kinetic energy that this car has lost.

Initial kinetic energy of this car:

$\begin{aligned}& \text{KE(initial)}\\ &= \frac{1}{2} \, m \cdot {\left(v(\text{initial})\right)}^{2}\\ &= \frac{1}{2}\times 2200\; \rm kg \times {\left(31\; \rm m \cdot s^{-1}\right)}^{2} \\ &= 1.0571 \times 10^{6}\; \rm J\end{aligned}$ .

Kinetic energy of this car after it came to a complete stop:

$\begin{aligned}\text{KE(final)}= 0\; \rm J\end{aligned}$ .

Kinetic energy that this car has lost: $1.0571\times 10^{6}\; \rm J$ .

That should be the same as the magnitude of the work that this braking force has done. However, because this work is smaller than zero, the actual value of this work would be $\left(-1.0571\times 10^{6}\; \rm J\right)$ .

In this question, both the mass and the initial speed of this car are specified with only two significant figures each. Hence, round the result accordingly and keep only two significant figures: $\left(-1.1\times 10^{6}\; \rm J\right)$ .

Answer from: Quest

the answer is b

explanation:

Answer from: Quest

mistakes are ok

Another question on Physics

Physics, 22.06.2019 06:30

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?

Answers: 3

Answer

Physics, 22.06.2019 15:10

Suppose that f : rn → rm and that a ∈ k, where k is a connected subset of rn . suppose further that for each x ∈ k there exists a δx > 0 such that f(x) = f(y) for all y ∈ bδx (x). prove that f is constant on k; that is, f(x) = f(a) for all x ∈ k

Answers: 1

Answer

Physics, 22.06.2019 20:30

Light from two different sources are incident upon the same side of a polarizing filter. light from one source is polarized with total intensity ip, while light from the other source is unpolarized with total intensity iu. as you rotate the polarizing filter through 360 degrees, the intensity of the transmitted light on the other side varies by a factor of 9. what is the relative intensity of the initial polarized source to the unpolarized source, or ip/iu?

Answers: 2

Answer

Physics, 23.06.2019 02:30

What instrument is used to measure liquid volume?

Answers: 1

Answer

You know the right answer?

A 2200 kg car moving at 31 m/s comes to a complete stop. What is the work done by the breaks of the...

Questions