Physics, 10.01.2021 21:50 codycoker4200

8. Referring to the diagram below, the resultant force acting on the object is 1o
F-30N
F-60N
F; 100N
100NIZZ
int in 8 units

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 23:00

Athermometer is removed from a room where the temperature is 70° f and is taken outside, where the air temperature is 10° f. after one-half minute the thermometer reads 60° f. what is the reading of the thermometer at t = 1 min? (round your answer to two decimal places.) ° f how long will it take for the thermometer to reach 30° f? (round your answer to two decimal places.)

Answers: 3

Answer

Physics, 22.06.2019 02:10

"an open tank has the shape of a right circular cone. the tank is 6 feet across the top and 5 feet high. how much work is done in emptying the tank by pumping the water over the top edge? note: the density of water is 62.4 lbs per cubic foot."

Answers: 2

Answer

Physics, 22.06.2019 02:50

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

Answer

Physics, 22.06.2019 15:30

At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.

Answers: 1

Answer

You know the right answer?

8. Referring to the diagram below, the resultant force acting on the object is 1o
F-30N
F...

Questions