Physics, 17.12.2019 02:31 silvajimena74

States that energy cannot be created or destroyed.
a. newton’s second law
c. the law of conservation of energy
b. newton’s third law
d. boyle’s law

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 14:20

4r-134a enters the condenser of a residential heat pump at 800 kpa and 50°c at a rate of 0.022 kg/s and leaves at 750 kpa subcooled by 3°c. the refrigerant enters the compressor at 200 kpa superheated by 4°c determine (a) the isentropic efficiency of the compressor, (b) the rate of heat supplied to the heated room, and (c) the cop of the heat pump. also, determine (d) the cop and rate of heat supplied to the heated room if this heat pump operated on the ideal vapor-compression cycle between the pressure limits of 200 and 800 kpa. (0.757, 4.37 kw, 5.12, 6.18, 3.91 kw)

Answers: 3

Answer

Physics, 22.06.2019 23:00

Identify the type of heat transfer occurring when chocolate melts in your hand

Answers: 1

Answer

Physics, 23.06.2019 06:00

The frequency of a tuning fork can be found by the method shown. a long tube open at both ends is submerged in a beaker of water, and the vibrating tuning fork is placed near the top of the tube. the length l of the air column is adjusted by moving the tube vertically. the sound waves generated by the fork are reinforced when the length of the air column corresponds to one of the resonant frequencies of the tube. the smallest value for l for which a peak occurs in sound intensity is 7 cm. l what is the frequency of the tuning fork? the speed of sound in air is 345 m/s. answer in units of hz

Answers: 2

Answer

Physics, 23.06.2019 08:00

Athin electrical heater is inserted between a long circular rod and a concentric tube with inner and outer radii of 20 and 40 mm. the rod (a) has a thermal conductivity of ka = 0.15 w/(m*k), while the tube (b) has a thermal conductivity of kb = 0.8 w/(m*k) and its outer surface is subjected to convection with a fluid of temperature t= -15°c and heat transfer coefficient 60 w/(m2 *k). the thermal contact resistance between the cylinder surfaces and the heater is negligible. (a) determine the electrical power per unit length of the cylinders (w/m) that is required to maintain the outer surface of cylinder b at 15°c. (b) what is the temperature at the center of cylinder a?

Answers: 2

Answer

You know the right answer?

States that energy cannot be created or destroyed.
a. newton’s second law
c. the law o...

Questions