subject
Physics, 01.02.2021 21:20 serenityarts123

A student must determine the effect of friction on the mechanical energy of a small block as it slides up a ramp. The block is launched with an initial speed vo from point A along a horizontal surface of negligible friction. It then slides up a ramp, where fnction is not negligible, that is inclined at angle 0 with respect to the horizontal, as shown in the figure. The student measures the maximum vertical height h attained by the block while on the ramp, labeled as point B in the figure. At point B, the block comes to rest. The student performs three trials with the ramp at different angles, launching the block at the same initial speed vo for each trial. The results from the trials are displayed in the table, How should the student use the data collected and the known quantities from the experiment 19 determine the initial total mechanical energy of the block-ramp-Earth system for all trials in the experiment?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 15:00
If you were on a jury, do you think you would expect individual characteristics in the evidence? why or why not? what effects might it have if individuals expect to have individuals characteristics presented? this question is for forensic science
Answers: 2
question
Physics, 22.06.2019 03:00
Do you agree with scientist’s prediction about the warming of alaska and other polar regions?
Answers: 2
question
Physics, 22.06.2019 03:10
Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.
Answers: 2
question
Physics, 22.06.2019 14:30
Slab pull” is a type of tectonic plate movement that occurs due to the forces of mantle convection and results in the subduction of the lithosphere true or false
Answers: 2
You know the right answer?
A student must determine the effect of friction on the mechanical energy of a small block as it slid...
Questions
Questions on the website: 13722363