Physics, 24.02.2021 20:00 isaacb6727

Why is it important for scientist to do research?

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 20:50

Suppose that a mass of 2 kg is attached a spring whose spring constant is 50. the system is damped such that b = 12 . the mass is set in motion with an initial velocity of -8 m/s at a position 0 meters from equilibrium. set up and solve a differential equation that models this motion. write your solution in the form a cos ( ω t − α ) where α is a positive number. use your solution to fill in the information below: what is the amplitude of the motion? what is the value of ω ? what is the phase shift?

Answers: 1

Answer

Physics, 22.06.2019 21:00

Acentrifuge in a medical laboratory rotates at an angular speed of 3,700 rev/min. when switched off, it rotates through 54.0 revolutions before coming to rest. find the constant angular acceleration (in rad/s2) of the centrifuge. your response is within 10% of the correct value. this may be due to roundoff error, or you could have a mistake in your calculation. carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. rad/s2

Answers: 1

Answer

Physics, 22.06.2019 21:30

Contrast the force of gravity between these pairs of objects: 1-kg mass and a 2-kg mass that are 1 m apart; a 1-kg mass and a 2-kg mass that are 2 m apart; and two 2=kg masses that are 1 m apart. i dont understand.

Answers: 3

Answer

Physics, 23.06.2019 02:10

Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.