Answers: 3
Physics, 21.06.2019 16:00
Why does the input force have to be greater than the force needed to lift the bale?
Answers: 3
Physics, 21.06.2019 20:30
Water at room temperature of 20.0°c is poured into an aluminum cylinder which has graduation markings etched on the inside. the reading in the graduations is 300.0 cc. the cylinder with the water in it is then immersed in a constant temperature bath at a temperature of 100°c. what is the reading for the level of water on the graduations of the cylinder after the water and the cylinder reach thermal equilibrium with the bath? the volume coefficient of expansion of water is 2.07 x 10^-4 k-1, and the linear coefficient of expansion of aluminum is 23.0 x 10^-6 k-1. a) 305.0 cc b) 304.0 cc c) 303.5 cc d) 303.3 cc e) 304.5 cc
Answers: 3
Physics, 21.06.2019 22:50
Calculate the heat capacity per object when the total energy is 4 quanta. (think of this in terms of increasing from 3.5 quanta of energy in the system to 4.5 quanta of energy in the system, if that were possible.) c4 = __ j/k/object
Answers: 2
Physics, 22.06.2019 00:30
Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).
Answers: 2
A golf ball is hit at an angle of 30° above the horizontal with a velocity of 10.0 m/s. What is the...
Mathematics, 12.08.2020 07:01
Mathematics, 12.08.2020 07:01
Mathematics, 12.08.2020 07:01
English, 12.08.2020 07:01
History, 12.08.2020 07:01
Mathematics, 12.08.2020 07:01
Social Studies, 12.08.2020 07:01
Mathematics, 12.08.2020 07:01
History, 12.08.2020 07:01