subject
Physics, 03.04.2021 19:50 ash011519

2 Blocks 1 and 2 rest on rough surfaces with coefficient of frictions ¢1 and ¢2 respectively. The blocks are connected by a cable that runs over a smooth pulley and are in equilibrium as shown below with the following values.

W2 = 50N
thetha 1 = 30 degrees
thetha 2= 40 degrees
¢1= 0.3
¢2= 0.25

a. If Block 2 is on the verge of sliding down the plane, what is the minimum weight W1, required for equilibrium?
b. If Block 2 is on the verge of sliding up the plane, what is the minimum weight W1, required for equilibrium
? Do not consider overturning.​


2 Blocks 1 and 2 rest on rough surfaces with coefficient of frictions ¢1 and ¢2 respectively. The b

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 11:30
This punnett square shows the cross between two pants. one parent has round seeds (rr). and the other parent has wrinkled seeds (rr) which best describes their offspring as shown in this cross?
Answers: 1
question
Physics, 22.06.2019 17:40
Aspring is used to stop a 50-kg package which is moving down a 20º incline. the spring has a constant k = 30 kn/m and is held by cables so that it is initially compressed 50 mm. knowing that the velocity of the package is 2 m/s when it is 8 m from the spring and neglecting friction, determine the maximum additional deformation of the spring in bringing the package to rest.
Answers: 1
question
Physics, 23.06.2019 01:10
The path of a satellite orbiting the earth causes it to pass directly over two tracking stations a and b, which are 51 miles apart. when the satellite is on one side of the two stations, the angles of elevation at a and b are measured to be 87 degrees and 84 degrees, respectively. (a) how far is the satellite from station a? (b) how high is the satellite above the ground?
Answers: 3
question
Physics, 23.06.2019 02:50
Adielectric-filled parallel-plate capacitor has plate area a = 30.0 cm2 , plate separation d = 9.00 mm and dielectric constant k = 3.00. the capacitor is connected to a battery that creates a constant voltage v = 15.0 v . throughout the problem, use ϵ0 = 8.85x10-12 c2/n.m2 . find the energy u1 of the dielectric-filled capacitor.
Answers: 2
You know the right answer?
2 Blocks 1 and 2 rest on rough surfaces with coefficient of frictions ¢1 and ¢2 respectively. The bl...
Questions
question
History, 05.03.2020 00:24
question
Physics, 05.03.2020 00:25
Questions on the website: 13722361