subject
Physics, 06.04.2021 18:40 lizzyhearts

Extra points ! Will give brainliest to correct answer ! The diagram below shows forces acting on a model airplane. Both its speed and height above the ground are constant.
***diagram in photo***

Which of the following conditions would cause the model airplane to descend toward the ground?

A) The thrust is greater than the drag.
B) The thrust is equal to the weight.
C) The lift is less than the weight.
D) The lift is equal to the drag.


Extra points ! Will give brainliest to correct answer !

The diagram below shows forces acting on

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 05:30
The volume of a gas is halved during an adiabatic compression that increases the pressure by a factor of 2.5. what is the specific heat ratio? show the math steps .
Answers: 3
question
Physics, 22.06.2019 10:00
A2k pendulum has a speed of 1 m/s at a height of 1/2 meter
Answers: 3
question
Physics, 22.06.2019 19:00
Review multiple-concept example 7 in this chapter as an aid in solving this problem. in a fast-pitch softball game the pitcher is impressive to watch, as she delivers a pitch by rapidly whirling her arm around so that the ball in her hand moves in a circle. in one instance, the radius of the circle is 0.626 m. at one point on this circle, the ball has an angular acceleration of 66.1 rad/s2 and an angular speed of 12.6 rad/s. (a) find the magnitude of the total acceleration (centripetal plus tangential) of the ball. (b) determine the angle of the total acceleration relative to the radial direction.
Answers: 3
question
Physics, 23.06.2019 01:40
(8%) problem 12. a bowling ball of mass mb 3 kg 's rolled down the lane with a velocity ofy-2/ m s lt strikes a single remaining pin mp 0.93 kg head on. after the collision the bowling ball has a velocity (in the same direction) of v2 1.1 m/s. = ▲ 33% part (a) write an expression for the velocity of pin in the horizontal direction after the impact, im ,, 33% part (b) what is the pins speed in ms? 33% part (c) assuming the coefficient of friction s μ,-0.1. how far in meters could the pin slide before stopping if it doesn't topple?
Answers: 1
You know the right answer?
Extra points ! Will give brainliest to correct answer ! The diagram below shows forces acting on a...
Questions
Questions on the website: 13722360