QUESTION 3 A 10 kg cement block is pulled across the floor with a force of 50 N at an angle of 30° with the
horizontal The block accelerates at 1,5 m s?
30°
10 kg
(2)
31
Define the term normal force
3.2
Draw a FORCE DIAGRAM showing ALL the forces acting on the object.
3.3
Calculate the magnitude of the
(3)
3.3.1 Normal force
(5)
3.3.2 Frictional force which acts on the crate
(4)
3.3.3 Coefficient of kinetic friction
[18]​

Which device uses ac current to operate?

Apositive rod is placed to the left of sphere a, and the spheres are separated. which best describes the spheres? sphere a is negative and sphere b is positive because protons from sphere a are attracted to the rod and move to sphere b. sphere a is negative and sphere b is positive because electrons from sphere b are attracted to the rod and move to sphere a. sphere a is positive and sphere b is negative because electrons from the rod move to sphere b and protons then move to sphere a. sphere a is positive and sphere b is negative because protons move from sphere b to the rod and also to sphere a.

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)