You have a summer job working at a company developing systems to safely lower large loads down ramps. Your team is investigating a magnetic system by modeling it in the laboratory. The safety system is a horizontal conducting bar that can slide on two parallel conducting rails running down the sides of the ramp. At the bottom of the ramp, the two rails are connected to a power supply. The magnetic field is uniform and vertical. Required:
Your task is to calculate the maximum power supply voltage which holds the bar stationary, as a function of the mass of the bar, the strength of the magnetic field, the angle of the ramp from the horizontal, the length of the bar which is the same as the distance between the tracks, and the resistance of the bar. Assume that all of the other conductors in the system have a much smaller resistance than the bar.

The particle in a two-dimensional well is a useful model for the motion of electrons around the indole ring (3), the conjugated cycle found in the side chain of tryptophan. we may regard indole as a rectangle with sides of length 280 pm and 450 pm, with 10 electrons in the conjugated p system. as in case study 9.1, we assume that in the ground state of the molecule each quantized level is occupied by two electrons. (a) calculate the energy of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels. 9.27 electrons around the porphine ring (4), the conjugated macrocycle that forms the structural basis of the heme group and the chlorophylls. we may treat the group as a circular ring of radius 440 pm, with 20 electrons in the conjugated system moving along the perimeter of the ring. as in exercise 9.26, assume that in the ground state of the molecule quantized each level is occupied by two electrons. (a) calculate the energy and angular momentum of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels.

The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error

From 0 to 5 seconds john pushed a box 5 meters. from 5 to 10 seconds, paul pushed the same box another 5 meters. who did more work? a. john b. paul c. john and paul did the same amount of work.