subject
Physics, 20.09.2019 14:10 liliaboop5006

When finding the upper bound of the density, you put what number in the denominator?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 20:00
What happens to atoms and chemical bonds during a reaction?
Answers: 1
question
Physics, 22.06.2019 06:30
5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity Ο‰2 = ΞΈΛ™ 2 as a function of ΞΈ1, Ο‰1 = ΞΈΛ™ 1 and Ξ±. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot Ο‰2 over 0 ≀ ΞΈ1 ≀ 360deg with Ο‰1 = 360deg/sec. do this for Ξ± = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration Ο‰Λ™ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (Ο‰2 and Ο‰Λ™ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with Ξ± = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?
Answers: 3
question
Physics, 22.06.2019 06:30
Air initially at 0.75 bar, 1000 k, and occupying a volume of 0.12 m^3 undergoes two processes. process 1-2: the air is compressed isothermally until the volume is halved. process 2-3: the air undergoes a constant pressure process until the volume is halved again. assume ideal gas behavior. a) determine the mass of the air, in kg. b) the work and the heat transfer for each of the two processes, in kj. (100 kj = 1 bar . m^3)
Answers: 1
question
Physics, 22.06.2019 08:20
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
You know the right answer?
When finding the upper bound of the density, you put what number in the denominator?...
Questions
question
Mathematics, 11.03.2020 23:25
question
Social Studies, 11.03.2020 23:25
Questions on the website: 13722367