Physics, 21.09.2019 05:30 sadiesnider9

Apositive charge q is placed at the origin. four other positive charges are placed on a circle in the x-y plane centered on q as shown. the top charge is located on the y axis and has a magnitude of 3q. the three bottom charges are symmetric about the y axis as shown and each has magnitude q.
1) which of the following statements best describes fx, the x component of the net force on the charge at the origin
fx > 0
fx = 0
fx < 0
3) for the collection of charges shown in the above problem, which of the following statements best describes fy, the y component of the net force on the charge at the origin
fy > 0
fy = 0
fy < 0

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 00:10

The energy released by a chemical reaction can be measured using a calorimeter. when barium hydroxide octahydrate crystals are reacted with dry ammonium chloride inside of a coffee cup calorimeter, the temperature of the 18.00 g of water in the calorimeter decreases from 30.0°c to 8.0°c. the equation for calculating energy absorbed or released by a reaction is: where q is the energy released or absorbed, m is the mass of water in the calorimeter, cp is the specific heat of water, and δt is the observed temperature change. if the specific heat of liquid water is 4.19 j/g·°c, how much energy was absorbed by the reaction?

Answers: 3

Answer

Physics, 22.06.2019 02:00

Aplane travels 1000 miles in 5 hours .what is the planes average speed?

Answers: 2

Answer

Physics, 22.06.2019 05:00

Red light strikes a metal surface and electrons are ejected. if violet light is now used with a 10% greater intensity, what will happen to the ejection rate (number of ejected electrons per second) and the maximum energy of the electrons? a) greater ejection rate; same maximum energyb) same ejection rate; greater maximum energyc) greater ejection rate; greater maximum energyd) same ejection rate; same maximum energye) none of the above answers are correct

Answers: 1

Answer

Physics, 22.06.2019 10:50

Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.

Answers: 3

Answer

You know the right answer?

Apositive charge q is placed at the origin. four other positive charges are placed on a circle in th...

Questions

Physics, 08.06.2021 07:30

A spinning satellite begins to unfold two solar panels as shown. As the panels extend from the satellite, what is the result?