subject
Physics, 02.02.2020 22:02 nininichole431

Acathode ray tube is made of glass with a small amount of some kind of gas in it. it has metal electrodes at each end to pick up an electric current. the electrodes are named "positive” and "negative,” which were words used by benjamin franklin in the 1700s to describe electricity. a bright ray forms in the gas when an electric current is applied to metal electrodes. in the 1800s, an important scientist suspected that the negatively charged particles in a cathode ray were present in all atoms. what procedure would allow that scientist to investigate this idea?

a)observing if the cathode ray forms when the electric current is off
b)making cathode ray tubes out of different materials to see if the ray is the same
c)using different magnets to see if the cathode ray responds in the same way to each
d)changing the strength of the electric current and observe how the ray forms and changes

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 16:50
12 drag each label to the correct category. decide whether each statement describes mass or weight. measured in newtons measured in kilograms does not change when gravity changes === a gravitational force changes when gravity changes the amount of matter in something mass weight
Answers: 1
question
Physics, 21.06.2019 23:20
Initially, a particle is moving at 5.33 m/s at an angle of 37.9° above the horizontal. two seconds later, its velocity is 6.11 m/s at an angle of 54.2° below the horizontal. what was the particle's average acceleration during these 2.00 seconds in the x-direction (enter first) and the y-direction?
Answers: 1
question
Physics, 22.06.2019 04:50
Describe the function of the endomembrane system? what organelles are involved?
Answers: 3
question
Physics, 22.06.2019 08:20
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
You know the right answer?
Acathode ray tube is made of glass with a small amount of some kind of gas in it. it has metal elect...
Questions
question
English, 25.07.2019 13:30
Questions on the website: 13722367