Physics, 01.05.2021 20:50 BreadOfTheBear

One way to think about circular motion is that the object is continuously . A. Prevented from moving in a straight line.
B. Allowed to move in a straight line.
C. Forced to move in a straight line.
D. Encouraged to move in a straight line.

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 17:00

What would the difference of spectral lines emitted by hydrogen gas in distant galaxies which is normally found at a wavelength of 21 cm on earth, be observed at 21.1 centimeters?

Answers: 2

Answer

Physics, 22.06.2019 23:40

Along wire of diameter 1 mm is submerged in an oil bath of temperature ∞ 31°c. the wire has an electrical resistance per unit length of 0.01 ω/m. if a current of 103 a flows through the wire and the convection coefficient is 500 w/m2·k, what is the steady-state temperature of the wire? from the time the current is applied, how long does it take for the wire to reach a temperature that is within 1°c of the steady-state value? the properties of the wire are 8000 kg/m3, 500 j/kg·k, and 20 w/m·k.

Answers: 3

Answer

Physics, 23.06.2019 01:00

First answer marked as brainiest which is the correct equation describing the first law of thermodynamics? a) when the internal energy of a system changes, it equals the amount of heat added plus the work done. b) when work is done by the piston, it is equal to the heat added plus the change in internal energy of the system. c) when heat is added to the system, it is equal to the amount of work done by the piston plus the change in internal energy of the system.

Answers: 2

Answer

Physics, 23.06.2019 17:30

Wo dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Answers: 3

Answer

You know the right answer?

One way to think about circular motion is that the object is continuously . A. Prevented from movi...

Questions