Physics, 07.05.2021 01:00 oopsorry

A disk-shaped platform has a known rotational inertia ID. The platform is mounted on a fixed axle and rotates in a horizontal plane with an initial angular velocity of ÏD in the counterclockwise direction as shown. After an unknown time interval, the disk comes to rest. A single point on the disk revolves around the center axle hundreds of times before the disk comes to rest. Frictional forces are considered to be constant. In a different experiment, the original disk is replaced with a disk for which frictional forces are considered to be negligible. The disk is set into motion such that it rotates with a constant angular speed. As the disk spins, a small sphere of clay is dropped onto the disk, and the sphere sticks to the disk.

Required:
Write down the claims which are correct about the angular momentum and the total kinetic energy of the disk-sphere system immediately before and immediately after the collision.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 16:40

Aparticle's position is given by x = 3.00 - 9.00t + 3t2, in which x is in meters and t is in seconds. (a) what is its velocity at t = 1 s? (b) is it moving in the positive or negative direction of x just then? (c) what is its speed just then? (d) is the speed increasing or decreasing just then? (try answering the next two questions without further calculation.) (e) is there ever an instant when the velocity is zero? if so, give the time t; if not, answer "0". (f) is there a time after t = 3 s when the particle is moving in the negative direction of x? if so, give the time t; if not, answer "0".

Answers: 3

Answer

Physics, 23.06.2019 11:30

Awave is propagating from left to right in a medium. the particles in the medium are also vibrating from left to right. what kind of wave does this describe? a. longitudinal wave b. transverse wave c. mechanical wave d. electromagnetic wave

Answers: 1

Answer

Physics, 23.06.2019 13:20

Two wooden members of 80 × 120-mm uniform rectangular cross section are joined by the simple glued scarf splice shown. knowing that β = 22° and that the maximum allowable stresses in the joint are, respectively, 400 kpa in tension (perpendicular to the splice) and 690 kpa in shear (parallel to the splice), determine the largest centric load p that can be applied using mohr's circle. (round the final answer to two decimal places.)

Answers: 1

Answer

Physics, 23.06.2019 23:30

In the circuit shown in fig. e26.31 the batteries have negligible internal resistance and the meters are both idealized. with the switch s open, the voltmeter reads 15.0 v. (a) find the emf of the battery. (b) what will the ammeter read when the switch is closed

Answers: 1

Answer

You know the right answer?

A disk-shaped platform has a known rotational inertia ID. The platform is mounted on a fixed axle an...

Questions