subject
Physics, 10.05.2021 09:00 hugbug2554

examine the following graph. a) What is the amplitude of the oscillation? b) What is the period of the oscillation?​


examine the following graph. a) What is the amplitude of the oscillation? b) What is the period of

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 15:10
Difference between series and parallel circuits
Answers: 3
question
Physics, 23.06.2019 00:30
Two waves maximally constructively interfere at a point in space. among the options below, select the possible value of their phase difference at that point in space.a. zerob. πc. π/2d. not determinable by the information provided
Answers: 3
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
question
Physics, 23.06.2019 08:00
Athin electrical heater is inserted between a long circular rod and a concentric tube with inner and outer radii of 20 and 40 mm. the rod (a) has a thermal conductivity of ka = 0.15 w/(m*k), while the tube (b) has a thermal conductivity of kb = 0.8 w/(m*k) and its outer surface is subjected to convection with a fluid of temperature t= -15°c and heat transfer coefficient 60 w/(m2 *k). the thermal contact resistance between the cylinder surfaces and the heater is negligible. (a) determine the electrical power per unit length of the cylinders (w/m) that is required to maintain the outer surface of cylinder b at 15°c. (b) what is the temperature at the center of cylinder a?
Answers: 2
You know the right answer?
examine the following graph. a) What is the amplitude of the oscillation? b) What is the period of t...
Questions
Questions on the website: 13722367