At the end of 3N force acts on the object during time interval of 1.5seconds with force acting towards right. A constant force of 4N to left is applied for 3seconds. What is the velocity at the end of the 3seconds ?

v_f = -7.5 m / s

Explanation:

Let's analyze this exercise a little, two forces that act on a body for different time intervals are indicated, each force creates an impulse and since this is a vector quantity we must add in the form of vectors. The net momentum is

we assume that the direction to the right is positive

             I = I₁ + I₂

             I = F₁ Δt₁ - F₂ Δt₂

             I = 3  1.5 - 4  3

             I = -7.5   N s

now let's use the relationship between momentum and momentum, suppose the object starts from rest (vo = 0)

             I = Δp

             I = m (v_f - v₀)

             v_f = I / m

              v_f = -7.5 / m

to finish the calculation we must assume a mass m = 1 kg

              v_f = -7.5 m / s

the negative sign in the body is moving to the left

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

i would like to make dinner for my mom, dad, and sister