subject
Physics, 21.05.2021 14:00 madisonbrookecallis

A massive, uniform rod of length L= 10 meters is pivoted at its bottom end. It is held veritcal initially, as shown in the figure, and is released. It, then, swings down rotating around the pivot, as indicated in the figure. When the rod completes three-quarters of a full turn, at the instant the rod reaches the horizontal position as indicated by the dashed lines in the figure, the pivot disappears and the rod flies freely up in the air. (Take g = 10 m/s^2.)

A) What is the angular speed w, in units of radians per second, of the rod about the pivotal point when it reaches the horizontal position indicated by the dashed lines in the figure?

B) What is the maximum height h, in meters, from the horizontal level indicated by the dashed lines in the figure, that the center of mass of the rod reaches during the resulting motion after the pivot disappears and the rod
flies freely up in the air?

C) What the angle 0, in degrees, that the rod makes with respect to the horizontal (0°
D) If the pivot disappears when the rod is at an angle 30° below the horizontal position indicated by the dashed lines in the figure, what angle, in degrees, does the rod rotate about the center of mass between the instant the
pivot disappears and the instant the center of mass reaches its maximum height? (30° is the angle between the horizontal indicated by the dashed lines and the rotating rod at the instant the pivot disappears.)

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 12:10
An ionic compound can conduct electricity when a it is dissolved in water b its crystals are ground into powder c it is in solid form d it is heated to just below its melting point
Answers: 1
question
Physics, 22.06.2019 17:20
Scientific models are based on current knowledge, which can limit their effectiveness when new discoveries are made.
Answers: 1
question
Physics, 23.06.2019 00:40
Aforce of 8,480 n is applied to a chart to accelerate it at a rate of 26.5 m/s2. what is the mass of the cart?
Answers: 1
question
Physics, 23.06.2019 01:30
Acyclotron is used to produce a beam of high-energy deuterons that then collide with a target to produce radioactive isotopes for a medical procedure. deuterons are nuclei of deuterium, an isotope of hydrogen, consisting of one neutron and one proton, with total mass 3.34×10−27kg. the deuterons exit the cyclotron with a kinetic energy of 6.40 mev .a-what is the speed of the deuterons when they exit? b-if the magnetic field inside the cyclotron is 1.25 t, what is the diameter of the deuterons' largest orbit, just before they exit? c-if the beam current is 350 μa how many deuterons strike the target each second?
Answers: 3
You know the right answer?
A massive, uniform rod of length L= 10 meters is pivoted at its bottom end. It is held veritcal init...
Questions
question
Computers and Technology, 15.04.2021 20:50
Questions on the website: 13722361