A car with mass 1990 kg crashes into a wall. The car’s velocity immediately before the collision was 10.8 m/s and the bumper is compressed like a spring with spring constant
1.14 × 107 N/m.
What is the maximum deformation of the
bumper for this collision?
Answer in units of m.

For problems 1-3, consider a simple dc brush motor with a permanent magnet stator. with an an consider a simple dc brush motor with a permanent magnet ae supply voltage of 100 v, the no-load speed of the motor is 1000 rpm. this motor can provide a torque of 1.9 n-m at 800 rpm drawing a current of 2 a current are both zero at no load.) 1. with an armature supply voltage of 100 v, the motor is operated at 900 rpm. what is the motor torque? what is the mechanical power delivered by the motor? what is the current draw? what is the electrical power input? what is the energy efficiency of the motor? with an armature supply voltage of 100 v, the motor is operated at 1100 rpm (where it acts as a generator). what torque input is required? what mechanical power is required what current is generated? what is the electrical power generated? what is the energy efficiency of the motor acting as a generator? 2. with an armature supply voltage raised to 120 v, the motor is operated at 1000 rpm. what is the no-load speed? what is the motor torque? what is the mechanical power delivered by the motor? what is the current draw? what is the electrical power input what is the energy efficiency of the motor? 3.

Jenny wants to test the electrical conductivity of two substances dissolved in water. she is preparing the containers for the experiment. which factor is most important for her to control? a) volumes of the solutions b) appearance of the solutions c) temperatures of the solutions d) concentrations of the solutions

Adisk with a radius of r is oriented with its normal unit vector at an angle q with respect to a uniform electric field. which of the following would result in an increase in the electric flux through the disk? check all that apply? a. increasing the area of the disk b. decreasing the given orientation angle of the disk c. decreasing the strength of the electric field d. increasing the given orientation angle of the disk, but not exceeding an angle of 90