Physics, 15.06.2021 17:20 szinx

Adding salt
variable)
causes the boiling temperature of the water
variable) to increase.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 01:50

Arod of some material 0.20 m long elongates 0.20 mm on heating from 21 to 120°c. determine the value of the linear coefficient of thermal expansion [in (degrees c)^-1] for this material.

Answers: 2

Answer

Physics, 22.06.2019 14:50

Nitrogen (n2) undergoes an internally reversible process from 6 bar, 247°c during which pν1.2 = constant. the initial volume is 0.1 m3 and the work for the process is 121.14 kj. assuming ideal gas behavior, and neglecting kinetic and potential energy effects, determine heat transfer, in kj, and the entropy change, in kj/s. show the process on a t-s diagram.

Answers: 2

Answer

Physics, 23.06.2019 10:10

Now that we have a feel for the state of the circuit in its steady state, let us obtain the expression for the current in the circuit as a function of time. note that we can use the loop rule (going around counterclockwise): e−vr−vl=0. note as well that vr=ir and vl=ldidt. using these equations, we can get, after some rearranging of the variables and making the subsitution x=er−i, dxx=−rldt. integrating both sides of this equation yields x=x0e−rt/l. use this last expression to obtain an expression for i(t). remember that x=er−i and that i0=i(0)=0. express your answer in terms of e, r, and l. you may or may not need all these variables. use the notation exp(x) for ex.

Answers: 1

Answer

Physics, 23.06.2019 17:30

Wo dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Answers: 3

Answer

You know the right answer?

Adding salt
variable)
causes the boiling temperature of the water
variable) to inc...

Questions