subject
Physics, 04.09.2021 02:40 Dmgirl123

A. Spin the top more slowly. B. Spin the top faster.
C. Decrease the friction of the table.
D. Increase the height of the table.


A. Spin the top more slowly.

B. Spin the top faster.
C. Decrease the friction of the table.
D. In

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 13:40
An ideal otto cycle has a compression ratio of 10.5, takes in air at 90 kpa and 40°c, and is repeated 2500 times per minute. using constant specific heats at room temperature, determine the thermal efficiency of this cycle and the rate of heat input if the cycle is to produce 90 kw of power.
Answers: 2
question
Physics, 22.06.2019 14:10
Click the game tab at the bottom of the simulation and select level 1. (there is no seesaw balance for this part of the activity.) balance the first equation, and click check to see if you got it right. if you can’t balance it in the first try, you can try again. work through the five equations for level 1. click continue to go on to level 2, and later level 3. each level is more difficult than the one before. keep trying until all the equations are balanced. in one or two sentences, describe how you did in the balancing game. in a few more sentences, explain one strategy you learned for balancing more complex equations.
Answers: 2
question
Physics, 22.06.2019 15:20
Abag of potato chips contains 2.00 l of air when it is sealed at sea level at a pressure of 1.00 atm and a temperature of 20.0 deg c. what will be the volume of the air in the bag if you take it with you, still sealed, to the mountains where the temperature is 7.00 deg c and atmospheric pressure is 70.0 kpa? assume that the bag behaves like a balloon and that the air in the bag is in thermal equilibrium with the outside air.
Answers: 3
question
Physics, 22.06.2019 18:50
Avertical clean glass piezometer tube has an inside diameter of d = 1 mm and is used to measure pressure in a horizontal pipe carrying water as shown. due to pressure in the pipe, the water at 20c rises into the tube to a height h. if the water pressure in the pipe is p = 500 pa gauge, estimate the height h: (a) without considering surface tension (b) with surface tension (capillary) effects. the contact angle  can be assumed at 30 deg
Answers: 2
You know the right answer?
A. Spin the top more slowly. B. Spin the top faster.
C. Decrease the friction of the table.<...
Questions
question
Mathematics, 26.12.2019 21:31
question
Social Studies, 26.12.2019 21:31
Questions on the website: 13722362