Question 10 of 25 Which statement describes a possible limitation in an experimental design?
A. There is a large number of constants.
B. Collecting samples to analyze is very expensive.
C. The experiment has a very simple procedure.
D. The subject of the experiment has been studied by other
scientists
SUB
De

Initially, a particle is moving at 5.33 m/s at an angle of 37.9° above the horizontal. two seconds later, its velocity is 6.11 m/s at an angle of 54.2° below the horizontal. what was the particle's average acceleration during these 2.00 seconds in the x-direction (enter first) and the y-direction?

The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.

Four 5-gram blocks of metal are sitting out in the sun and absorb the same amount of heat energy. use the following specific heat capacity data to determine which block will increase its temperature the most.