NEED ANSWER ASAP! Which statement about a converging lens is not correct?

A ray parallel to the principal axis of the lens is refracted through the principal focus.

B All rays of light refracted by the lens pass through the principal focus.

C The distance between the centre of the lens and the principal focus is the focal length

D The principal focus of the lens is a point on the principal axis.

Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)

Utah's great salt lake has an average salinity seven times higher than that of the oceans. very few multicellular organisms live in this harsh environment. an example is the brine shrimp, which must devote a large portion of its metabolic energy to osmoregulation. these brine shrimp must available hint(s)utah's great salt lake has an average salinity seven times higher than that of the oceans. very few multicellular organisms live in this harsh environment. an example is the brine shrimp, which must devote a large portion of its metabolic energy to osmoregulation. these brine shrimp must pump water back into their cells to counter its loss due to osmosisactively pump water back out of their cells to counter its inflow due to osmosissynthesize membranes that are impermeable to substances that upset osmotic balanceactively pump salt back out of their cells to counter its inflow due to osmosis

Assume you measured the mass of the cart to be (500 ± 1) g and the mass of the additional mass you put on the cart to be (500 ± 1) g as well. since the scale you are using in the lab cannot measure objects heavier than 600g you will have to sum up individual pieces and propagate the error. so what would be the mass and the standard error of the cart and the mass