Newton's 2nd Law Logic Puzzle Karla, Matthew. Daneisha, Vince, and Sergio all have carts of different masses. In their tab, they each apply a different
amount of force to the carts, resulting in different accelerations. However, they did not label their data table and are
now trying to backtrack and identify all of their data
Your task: using the clues below and your understanding of Newton's 2 Law of Motion, help each student
determine the mass of their cart, the acceleration of their cart, and the force they each gave to their cart.

Abug is 12 cm from the center of a turntable that is rotating with a frequency of 45 rev/min . what minimum coefficient friction is required so that the bug stays on the turntable?

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

Which of the following changes will increase the capacitance of a parallel-plate capacitor? (there could be more than one correct choice.) a) increase the charge on the plates b) decrease the poten5al between the plates c) increase the potential between the plates d) introduce a dielectric material between the plates e) decrease the separation between the plates