Physics, 18.01.2022 03:00 kenxkeith

1. Describe your egg drop apparatus and at least three (3) design features you implemented in order to try to help your egg survive. 2. Provide a rationale for all of the materials you used. Why did you choose the materials you used?

5. Does the mass of a device matter? Why or why not.

6. If you could change 1 feature of your design, what would it be and why?

A well detailed physics sentence

Answers: 2

Show answers

Answers

Answer from: angelteddy033

Explanation:

There are three basic ways to increase the likelihood of safely dropping an egg:

Slow down the descent speed.

Parachutes are an obvious method for slowing the decent speed, as long as the design includes a way to keep the parachute open.

Cushion the egg so that something other than the egg itself absorbs the impact of landing.

The largest end of the egg has an area of air trapped between the egg's two membranes. This air space forms when the contents of the egg cool and contract after the egg is laid. It accounts for the crater you often see at the end of a hard-cooked egg. Upon impact the heavier spherical yolk continues moving towards the ground. The compression of the airspace acts like an air bag for the eggs' valuable contents. Building an artificial cushioning device will also help absorb the impact of landing.

Orient the egg so that it lands on the strongest part of the shell.

The arch structure at either end of the egg is stronger than its sides. Pressure is distributed down (or up) the arches so that less pressure acts on any one point. Orienting the arch downwards will increase the egg's survival.

Hope this helps you

Answer from: Quest

Efficiency is an act of doing something

Answer from: Quest

a longitudinal wave moves energy that is to the direction of the wave’s movement. - true

Another question on Physics

Physics, 22.06.2019 01:10

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Answers: 3

Answer

Physics, 22.06.2019 02:00

Figure 9 on page 362 shows various motions of balls. the curved path followed by the yellow ball in b in picture b is result of a) inertia b) centripetal motion c) gravity and horizontal velocity d) linear motion

Answers: 3

Answer

Physics, 22.06.2019 03:50

Aspecimen of oil having an initial volume of 580cm^3 is subjected to a pressure increase of 4.0 mpa, and the volume is found to decrease by 0.40 cm^3. (a) what is the bulk modulus of the material? (b) what is the compressibility of the material?

Answers: 1

Answer

Physics, 22.06.2019 11:50

Question 1 (5 pts): what is the maximum distance for which you can you resolve the two individual headlights of an on-coming truck as two separate lights rather than one if the headlights are separated by 2.00 m and your eye has a diameter of 1.00 centimeter? assume a wavelength of 500 nm.

Answers: 2

Answer

You know the right answer?

1. Describe your egg drop apparatus and at least three (3) design features you implemented in order...

Questions