Physics, 02.02.2022 05:30 kaylaaaaaaa86

A planet exerts a gravitational force of magnitude 6e22 N on a star. If the planet were 3 times closer to the star (that is, if the distance between the star and the planet were 1/3 what is is now), what would be the magnitude of the force on the star due to the planet?

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 02:10

How is coal extracted from mountaintop removal mines? a. dynamite is used to create underground tunnels where miners go to extract the coal. b. dynamite is used to break apart rocks and then draglines are used to remove the broken rock and reach the coal. c. coal in mountaintops is extracted by digging strips in the landscape to reach the coal. d. placer deposits in mountain river bottoms are removed by

Answers: 2

Answer

Physics, 22.06.2019 19:40

It may seem strange that the selected velocity does not depend on either the mass or the charge of the particle. (for example, would the velocity of a neutral particle be selected by passage through this device? ) the explanation of this is that the mass and the charge control the resolution of the device--particles with the wrong velocity will be accelerated away from the straight line and will not pass through the exit slit. if the acceleration depends strongly on the velocity, then particles with just slightly wrong velocities will feel a substantial transverse acceleration and will not exit the selector. because the acc

Answers: 1

Answer

Physics, 23.06.2019 06:30

Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?

Answers: 2

Answer

Physics, 23.06.2019 13:20

Two wooden members of 80 × 120-mm uniform rectangular cross section are joined by the simple glued scarf splice shown. knowing that β = 22° and that the maximum allowable stresses in the joint are, respectively, 400 kpa in tension (perpendicular to the splice) and 690 kpa in shear (parallel to the splice), determine the largest centric load p that can be applied using mohr's circle. (round the final answer to two decimal places.)

Answers: 1

Answer

You know the right answer?

A planet exerts a gravitational force of magnitude 6e22 N on a star. If the planet were 3 times clos...

Questions