Currently you sell a resistor that has a length of 9 cm, a cross-sectional area of 3 cm2 and uses Metal A with an electrical resistivity of 2 ohm-cm. Unfortunately the melting point of the resistive metal is too low and these resistors keep failing due to melting in operation. You are asked to design a new resistor with the same resistance using Metal B which has a higher melting temperature. Metal B has an electrical resistivity of 6 ohm-cm. What would you recommend for its design

1.in one challenge on the titan games, competitors have to lift 200 pounds up a long ramp. angel is able to move the weight in 42 seconds. anthony gets it done in only 38 seconds. which statement is true? angel has more power than anthony. angel does more work than anthony. anthony does more work than angel. anthony has more power than angel. 2.a mountain climber exerts 41,000 j of work to climb a cliff. how much power does the climber need if she wants to finish in only 500 seconds? power = work / time 20,500,000 watts 82 watts 0.0122 watts 41,500 watts 3.your family is moving to a new apartment. while lifting a box 83 joules of work is done to put the box on a truck, you exert an upward force of 75 n for 3 s. how much power is required to do this? (hint: you only need two of the 3 numbers given! ) power = work / time 249 watts 25 watts 2075 watts 27.7 watts

Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 âµm, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 ă— 104 n/c, what is the total positive charge on the central wire?

The gun from the crime scene shows tool marks where the serial numbers are ground off. there are also tool marks on the bullets left behind. what information can the tool marks on the bullets and gun provide about the crime? what type of evidence does this information provide, individual or class?