Physics, 23.07.2019 06:40 ykpwincess

When this type of rock breaks, it breaks into layers. a. igneous b. sedimentary c. foliated d. nonfoliated

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 22:00

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Answers: 1

Answer

Physics, 22.06.2019 14:00

Estimate the change in the gibbs energy and molar gibbs energy of 1.0dm3 of octane when the pressure acting on it is increased from 1.0 atm to 100 atm. the mass density of octane is 0.703 g cm−3

Answers: 3

Answer

Physics, 22.06.2019 17:00

The chart shows the costs and shipping times for materials that a company needs to build a new product. which describes the best trade-off if the company needs to start building their product within the next two years? they should order the domestic materials because it is always best to choose the fastest shipping time. they should order the imported materials because it is always best to choose the lowest cost for materials. since the shipping time is longer, they should order the domestic materials because the additional cost is worth it to get the materials in time. even though the shipping time is longer, they should order the imported materials because they are less expensive and should arrive in plenty of time to build the product.

Answers: 1

Answer

Physics, 23.06.2019 03:00

Use the library or internet to research each planet. make a chart comparing the following: approximate surface temperature relative surface gravity compared to earth atmospheric gases water in any form: solid, gas, or liquid when you have completed your chart, use the information you have collected to answer the following questions: which is the hottest planet? which is the coldest planet? which planet's temperature is closest to that of earth? (note: water boils at 100°c/212°f. water freezes at 0°c/32°f) which planet has the greatest gravitational attraction? which planet has the least gravitational attraction? which planet's gravitational pull is closest to that of earth? do any of the planets have oxygen in their atmosphere? which planet's atmosphere most resembles that of earth? do any of the planets have flowing water? which planet's water resources (solid, gas, or liquid) might be close to the amount on earth? which planet most resembles earth in terms of all of the factors: temperature, gravity, atmosphere, and water? if earth became an uninhabitable planet, which planet do you think would be the next best to live on? explain your answer.

Answers: 2

Answer

You know the right answer?

When this type of rock breaks, it breaks into layers. a. igneous b. sedimentary c. foliated d. nonfo...

Questions