subject
Physics, 24.07.2019 13:20 PrincessAlaia01

If you could go a year into the future, or 3 seconds into the past, where would you go? what date? i would go to june 6th, 2018 because that's when my school lets out.

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 12:00
Aboat radioed a distress call to a coast guard station. at the time of the call, a vector a from the station to the boat had a magnitude of 45.0 km and was directed 15.0Β° east of north. a vector from the station to the point where the boat was later found is = 30.0 km, 15.0Β° north of east. what are the components of the vector from the point where the distress call was made to point where the boat was found? in other words, what are the components of vector c = b - a?
Answers: 3
question
Physics, 22.06.2019 19:50
The heater element of a 120 v toaster is a 5.4 m length of nichrome wire, whose diameter is 0.48 mm. the resistivity of nichrome at the operating temperature of the toaster is 1.3 Γ— 10-6 ω·m. the toaster is operated at a voltage of 120 v. (a) what is the power drawn by the toaster? (b) if the cost of electricity is 12 Β’ per kilowatt-hour, and it takes 2 minutes to toast bread, how much does it cost for toasted bread? (c) when the heater element is at room temperature, is the resistivity in the nichrome wire greater than, less than, or equal to it’s resistivity when at operating temperature? explain.
Answers: 3
question
Physics, 23.06.2019 18:50
What is the ultimate purpose of the nuclear reaction in a nuclear power plant? -the reaction is used to create a magnetic field. -the reaction is used to create temperatures high enough to generate steam. -the reaction is used to create a high pressure system used to spin the turbine of the generator. -the reaction is used to prevent chain reactions. in a safety seminar at a nuclear power plant, a technician describes the procedure used if temperatures in the reactor become too high. what procedures should the technician describe? select all that apply. -more coolant will be pumped into the reactor. -the control rods will be taken out of the reactor. -the fuels rods will be lowered into the reactor. -the control rods will be lowered into the reactor. during a lab experiment demonstrating the relationship between pressure and water, mr. demming puts a beaker of water into a vacuum chamber. once the chamber is sealed, mr. demming turns the vacuum on. as the pump starts to take air out of the chamber, the air pressure inside drops relative to the pressure outside the chamber. after a few minutes, there is next to no air pressure in the chamber. what do you expect to observe in the experiment? -the beaker of water will crack. -the boiling point of the water will decrease and begin to boil at room temperature. -the boiling point of the water will increase, and will only boil at temperatures higher than 212 degrees f. -the liquid water will expand and spill out of the beaker since the air pressure no longer compresses the water molecules.
Answers: 1
question
Physics, 23.06.2019 20:00
If 25 ml of each of the liquids in the answer choices below were poured into a 100 ml beaker, which would form the second from the bottom layer? a. sea water – density of 1.024 g/ml b. mineral oil – density of 0.910 g/ml c. distilled water – density of 1.0 g/ml d. petroleum oil – density of 0.820 g/ml
Answers: 1
You know the right answer?
If you could go a year into the future, or 3 seconds into the past, where would you go? what date?...
Questions
question
English, 19.10.2019 12:30
question
Computers and Technology, 19.10.2019 12:30
question
Mathematics, 19.10.2019 12:30
question
Mathematics, 19.10.2019 12:30
Questions on the website: 13722362