subject
Physics, 17.10.2019 21:00 meganwintergirl

Which criteria determine whether a heterogeneous mixture is a colloid or a suspension?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
question
Physics, 22.06.2019 03:30
The solar panels used by mark function because of the photoelectric effect. light shines on the cells causing electrons to be ejected from the metal, which produces an electric current. at night on mars, no light will fall on the solar cells and no electric current will be generated. according to your notes, what type of light is typically needed to cause the photoelectric effect? a)visible b)ultraviolet c)infrared
Answers: 1
question
Physics, 22.06.2019 15:30
Match each scenario to the form of energy it represents
Answers: 2
You know the right answer?
Which criteria determine whether a heterogeneous mixture is a colloid or a suspension?...
Questions
Questions on the website: 13722361