Over the years most technology has gotten? smaller heavier less complicated ** more expensive

Aturntable that spins at a constant 74.0 rpm takes 3.10 s to reach this angular speed after it is turned on. find its angular acceleration (in rad/s2), assuming it to be constant, and the number of degrees it turns through while speeding up.

Aball is thrown from the top of a building with an initial velocity of 21.9 m/s straight upward, at an initial height of 51.6 m above the ground. the ball just misses the edge of the roof on its way down, as shown in the figure. (a) determine the time needed for the ball to reach its maximum height. (b) determine the maximum height. (c) determine the time needed for the ball to return to the height from which it was thrown, and the velocity of the ball at that instant. (d) determine the time needed for the ball to reach the ground. (e) determine the velocity and position of the ball at t = 5.35 s.

Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.